The leaf blower is a light, flexible, and highly efficient environmentally friendly tool. The gasoline engine drives the impeller to move in the volute, generating high-field airflow to complete the operation. Mainly used for forest and grassland fire extinguishing, sweeping fallen leaves, road dust, garbage, etc., it can also be used for snow removal in winter greenhouses, asphalt paving on engineering pavement walls or dust removal of the base layer before painting. The leaf blower has greatly solved the problem of lawn leaf accumulation, gaining a great number of reputations.
Introduction of leaf blower
The road surface is cleaned by gasoline leaf blower, functionally it can clean up gravel, dust, snow blowing, high-pressure wind fire and other functions! The newly developed high-power, high-speed backpack leaf blower. The engine has been comprehensively improved to greatly increase its efficiency. It is suitable for professional fire fighting in forests and grasslands, and can also be used for civil aviation, railway snow blowing, and road cleaning. It can be operated behind the back, and it is much more flexible than the traditional portable wind blower, and it can clean fallen leaves and garbage more effectively, which greatly improves the effectiveness of the lawn care and saves a great deal of time.
Starting of the leaf blower engine
1. When starting, the choke door should be opened when the car is cold, and the choke door is not needed when the car is hot, and the manual oil pump is pressed more than 5 times. 2. Land the machine motor support and the shackle on the ground, and place them firmly in a safe position. If it is necessary, you ought to place the shackle on a higher position and remove the chain protection device. The chain cannot touch the ground or other objects. 3. You should choose a safe position and stand firmly. It’s a great choice to use your left hand to firmly press the machine on the ground at the fan housing, with your thumb under the fan housing, and you’d better not step on the protective tube or kneel on the machine. 4. What you should pay attention is that yous should pull out the starting rope slowly until it stops, and then pull it out quickly and forcefully after rebounding. 5. If the carburetor is adjusted properly, the cutting tool chain cannot rotate in the idle position. 6. When there is no load, the throttle should be moved to the idle speed or low throttle position to prevent runaway; the throttle should be increased when working. 7. When all the oil in the oil tank is used up and refuel, the manual oil pump should reduce the pressure 5 times before restarting.
Did you find this helpful? Share it with your friends!